Output Power and Power Factor

Within the Advanced Settings menu is a submenu called "Power Control". In this menu there are two settings that can be adjusted: Output Power and Power Factor.

Output Power is the amount of energy that the inverter is allowed to generate (output). This value is adjusted based on a percentage. At 100% the inverter will produce whatever the nameplate rating is at most. For example, a 100K inverter will product 100K maximum. At 90% then the 100K will produce 90K maximum. This value can be increased beyond 100% as well. 

The Output Power menu for the Solis RHI-1P(5-10)K-HVES-5G-US inverter is in a different place from other Solis inverter series. After selecting Advanced Settings the password should instead be 2017 - press Up, Up, Down, Down, Up, Down, Up, Up, Up, Up, Up, Up (x7 Ups) then Enter.  The Output Power setting can be found within "Power Control". You must turn Backflow Power to OFF in order for the output power to remain adjusted. 

Power Factor is a measure of the phase difference between the AC voltage and current. If the voltage and current have no phase difference then we call this "unity power factor". Inductive and capacitive loads will cause the current to "lead" ahead ir "lag" behind the voltage, this creates a non-unity power factor. Reactive power is measured in "vars" while apparent power is measured in volt-amperes (VA). The reactive power is the "phase angle" between active power and apparent power. 

Solis inverters allow the Power Factor to be adjusted. This setting is found in the "Power Control" sub-menu of Advanced Settings. Make sure to adjust "Rea_P with Restore" so that the changes stay saved

Source: https://www.gses.com.au/wp-content/uploads/2016/03/GSES_powerfactor-110316.pdf

M
Michael.allen is the author of this solution article.

Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.